PathFollow2D

Category: Core

Point sampler for a .

This node takes its parent Path2D, and returns the coordinates of a point within it, given a distance from the first vertex.

It is useful for making other nodes follow a path, without coding the movement pattern. For that, the nodes must be descendants of this node. Then, when setting an offset in this node, the descendant nodes will move accordingly.

cubic_interp

Setter	set_cubic_interpolation(value)
Getter	get_cubic_interpolation()

The points along the Curve2D of the are precomputed before use, for faster calculations. The point at the requested offset is then calculated interpolating between two adjacent cached points. This may present a problem if the curve makes sharp turns, as the cached points may not follow the curve closely enough.

There are two answers to this problem: Either increase the number of cached points and increase memory consumption, or make a cubic interpolation between two points at the cost of (slightly) slower calculations.

float h_offset

Setter	set_h_offset(value)
Getter	get_h_offset()

The node’s offset along the curve.

lookahead

How far to look ahead of the curve to calculate the tangent if the node is rotating. E.g. shorter lookaheads will lead to faster rotations. Default value: .

Setter	set_loop(value)
Getter	has_loop()

float offset

Setter	set_offset(value)
Getter	get_offset()

The distance along the path in pixels.

rotate

If , this node rotates to follow the path, making its descendants rotate.

float unit_offset

Setter	set_unit_offset(value)
Getter	get_unit_offset()

The distance along the path as a number in the range 0.0 (for the first vertex) to 1.0 (for the last). This is just another way of expressing the offset within the path, as the offset supplied is multiplied internally by the path’s length.

Setter	set_v_offset(value)
Getter	get_v_offset()

The node’s offset perpendicular to the curve.