Other

    Reference

    The Curve draw tool allows you to free-hand draw curves.

    • Error
    • Error distance in object units. This can be seen similar to a subdivision rate for the curve.Lower values give a result that is closer to the drawing stroke while higher values give more smoothed results.
    • Fit Method
      • Refit
      • Incrementally re-fits the curve (gives best results).
      • Split
      • Splits the curve until the tolerance is met (gives a better drawing performance).
    • Corner Angle
    • Any angles above this are considered corners.
    • Cyclic
    • Toggles whether or not the curve is .

    Reference

    • Type

    • Type of curve to use for drawing.

      • Bézier Curve with straight line segments (auto handles).
      • Bézier
        • Tolerance
        • Lower values give a result that is closer to the drawing stroke,while higher values give more smoothed results.
        • Method
          • Refit
          • Incrementally re-fits the curve (gives best results).
          • Split
          • Splits the curve until the tolerance is met (gives a better drawing performance).
        • Detect Corners

        • Detects corners and uses non-aligned handles for them.

          • Corner Angle
          • Any angles above this are considered corners.
    • Pressure Radius
      • Min
      • Max
      • Radius to use when the maximum pressure is applied (or when a tablet is not used).
    • Projection Depth

    • Options to control where/how the curves are drawn.

      • Cursor
      • Uses the depth under the cursor to draw curves.
      • Surface
        • Offset
        • Distance to offset the curve from the surface.
        • Absolute Offset
        • Applies a fixed offset (does not scale by the curve radius).
        • Only First

        • Only uses the start of the stroke for the depth.

          • Normal/View
          • Draws perpendicular to the surface.
          • Normal/Surface
          • Draws aligned to the surface.
          • Draws aligned to the viewport.

    Reference

    Sets the curve's Weight for the selected control point to the specified value.If more than one control point is selected this will set the Mean Weight.

    Interactively places new points with Ctrl-RMB at the cursor position.With the selection it deals in same manner as the Extrude Curve and Move tool.